Borla Cat Back Exhaust System - 03-06 Infiniti G35 Sedan

This Borla Cat Back exhaust system has been designed for the 2003+ Infiniti G35 4 door sedan equipped with a 3.5L V6 engine and automatic or manual transmissions. The exhaust installs to the factory flanges located just after the catalytic converters and is made from full aircraft quality T304 stainless steel. It is a dual rear exiting system with a 4” Borla embossed single round, rolled edge, angle cut tip at each exit. This system consists of two 2.25” inlet pipe leading to a 19” long, 10” wide oval muffler. Exiting the muffler are two 2.25” pipes connecting to two 16” long, 5” diameter resonator mufflers. Following the resonators are two 2.25” over axle pipes leading to a single 10” long, 10” wide oval rear muffler. R&D testing has shown that our system flows up to 428.3 cfm more than the factory exhaust (for a total flow of 885.9 cfm @ 70psi) and has shown an increase of up to 14 additional horsepower and 11 ft. lbs. of torque. The Systems weights in at 51 lbs. while the factory system weights in at 74 lbs. This system averages 4 dba louder than the factory exhaust.

Does not fit the AWD models